【Product  Information】

MY-R-A001 is suitable for bonding un-vulcanized fluorosilicone rubber with metal, like iron, steel and  alloy, also has good adhesion effect with nylon, polyester, aramid and etc.

【Description】

【How  To  Use】

1.Surface treatment:

A: For metal: mechanical treatment(grit-blast), then degreasing, or use chemical methods to remove greasy diit, rust or other oxided layer;

B: For fabric: chemical treatment (steep fabric in 10%NaOH for 1 hour), then dry.

2. Dilution: coating directly, or can be diluted with ethyl acetate, toluene etc. To 50%~200% (volume   ratio). 

  3.Coating:brushing, dipping or spraying. Recommend the coating layer to be 0.03～0.08mm.

4. Dry: dry at room temperature (25℃~30℃) for 30mins, higher temperature(70℃~90℃) for 8~15mins. Could    get better effect to dry at lower temperature with faster gas flow.

5. Vulcanization: cure first stage at 170±5℃@10~15min, post-cured at 200℃@4hr:

【Product Performance】

1.One component,single layer coating, cure at high temperature. Strong adhesive strength after cure. Operating process is simple.

2.It has uniform color, not easy to get precipitated.

3.Waterproof, resistant to acid, alkali, chemical media. Not easy to get aged. Keep excellent adhesive effect for long time

【Package】

Plastic drums. Each drum is 100g/1kg/5kg/10kg.

【Storage】

Shall be stored in dry and ventilated places at room temperature (25℃).Validity is 6 months.

【Transportation】

Transport it as non-dangerous cargo.

【Attention】

1.Keep it intightly closed container, store at cool and dry place. Keep it away from heat and fire.

2. Should treat metal after surface treatment in time before oxided layer generates again; better finish coating in 2 hours after metal or fabric surface treatment.

3.If mucilage has some small amount of precipitation, stir it well before applying.

  4.Bonding after coating and drying immediately, avoid being contaminated and in touch with humid air.